Off grid office – Commercial Case Study using SoNick batteries

Posted on by Linda

Portable commercial office running in off grid situation.

Situated at a crushing plant used to crush concrete blocks for road fill. The portable office is placed near the weighbridge which didn’t have a grid connection to that particular part of site. Connecting to the grid was going to be very expensive and the portable off-grid hut was a perfect solution.

Battery usually discharges to around 50 – 60% capacity each day and is generally fully charged by 12 to 2pm each day.

Installation was easy as batteries could be installed anywhere in the office. As the SoNick battery doesn’t have any gasses given off no special enclosures were needed, unlike lead acid batteries which are what would have been used in this situation previously and would have needed a special room to contain gassing.

Continue reading “Off grid office – Commercial Case Study using SoNick batteries” →

Retrofitting a battery energy storage system

Posted on by Linda

Most people that are looking at installing an energy storage system (battery and battery inverter) don’t realise that every installation is different and there is no one size fits all. Installations are very dependent on whether there is already solar PV in place and the current electrical wiring situation at the premises.

When you decide to connect a battery energy storage system to your already installed solar panels there are things that need to be considered that may not become apparent until the actual installation is to take place. These may make installing the battery system much more difficult, costly and time consuming but actually has nothing to do with the actual battery system itself.

When a house is built an electrician will have wired the house and hopefully the wiring meets current electrical standards at the time. However, electrical standards change over time and older houses may not have electrical wiring that meets current standards. Also, particularly with older houses wiring may become damaged or wear out over time.

Continue reading “Retrofitting a battery energy storage system” →

Domestic Case Study using SoNick batteries – SA

Posted on by Linda

This domestic installation in rural South Australia was designed to run as a grid minimisation installation. Although the grid remains connected it is rarely used to power the house, although excess power is exported to take advantage of the feed in tariff available.

Before the battery installation this household had a 5 kW solar PV system installed with a Fronius solar inverter.

The battery installation was done in stages as requirements changed.

The original battery installation had one 9.6 kWh SoNick battery with 2 Victron 3 KVa Multigrid inverters and a Victron colour controller for communication.

Continue reading “Domestic Case Study using SoNick batteries – SA” →

Trailer and fixed installation – Domestic Case Study using SoNick batteries

Posted on by Linda

This domestic installation was on a farm. Initially a portable trailer was purchased. This trailer was used to take out on the farm to provide lighting where needed. This trailer had 1 x 7.7 kWh SoNick battery, a 5 kVa Victron Multiplus inverter and 3 x 250W solar panels. 3 panels are not enough to keep the batteries fully charged depending on how much power is drawn from the batteries. The trailer was then plugged in to the household power supply to recharge the batteries.

Continue reading “Trailer and fixed installation – Domestic Case Study using SoNick batteries” →

Tesla Victorian big battery fire

Posted on by Linda

The Tesla Victorian big battery fire at Moorabool near Geelong in Victoria is another example of why smaller community-based neighbourhood batteries are a preferable way forward for making the energy supply more renewable. With smaller installations that are more spread out and serve the community in which they are based there is less likelihood of larger electricity supply interruptions when a large power supplier has issues and has to be taken off line for safety reasons.

The 300MW/450MWH capacity big battery comprised of Tesla batteries in multiple shipping containers was registered with AEMO on 28th July 2021. During testing on 30th July 2021 one cell failed and caught fire and quickly engulfed the container in which the batteries were housed. This then spread to another container which was also destroyed. Luckily fire fighters were able to keep other containers cool enough so that they didn’t also catch fire. The blaze was finally extinguished 4 days later. 150 firefighters and 30 fire trucks and support vehicles attended the fire along with many other multi-agency specialists.

Continue reading “Tesla Victorian big battery fire” →

MIGROS gets the largest salt battery storage facility in Switzerland

Posted on by Linda

It’s great to see the newest installation of the #SoNick batteries in Switzerland by Innovenergy.

This installation is a 540 kWh salt battery storage system and now stands in the basement of MIGROS Schlieren/ZH. The molten salt batteries are 620V SoNick batteries supplied by FZSoNick and inverters by Indrivetec.

The SoNick batteries are charged with a large 806 KW solar PV system.

The purpose of the large-scale project is to save energy costs by optimising self-consumption. The other benefit is to maximise peak shaving which ensures the supermarket doesn’t have a lot of intermittent high energy draws which would increase energy bills substantially.

Continue reading “MIGROS gets the largest salt battery storage facility in Switzerland” →

What extended power outage teaches us about backup battery power

Posted on by Linda

Recently, after the severe weather event that hit Victoria on 9th June the ABC wrote an article comparing how a few different battery installations performed.

https://www.abc.net.au/news/2021-07-03/battery-power-dandenong-ranges-tesla-agm-grid/100264988

This article pointed out the importance of when purchasing an energy storage battery that it is fit for the purpose that you want it to provide.

Just like many people don’t initially realise that solar arrays don’t operate if the power is disconnected, battery storage systems don’t always work either.

This is fine if you just want a battery energy storage system to provide some load sharing but if you want power when the grid is disconnected the battery has to be capable of being used in an off-grid situation and it has to be wired to allow for this. This usually means the battery inverter is wired in before your solar inverter so that the complete battery and solar PV energy system can operate independently from the grid.

The type and size of your battery system is also important and how much of a battery systems capacity is actually useable. With lead acid and AGM batteries, generally only 30 – 50% of the batteries capacity is useable which means you will need a larger system capacity overall. Also as lead acid and AGM batteries tend to degrade over time and with use this needs to be taken into account when sizing your energy storage system.

Continue reading “What extended power outage teaches us about backup battery power” →

Not all batteries are equal

Posted on by Linda

With many households already having solar PV installations many people are now looking at energy storage systems to upgrade their home energy supply.

One of the most common questions is what battery is best for my needs. There is a lack of knowledge and a great amount of misinformation in the battery storage industry. It is critical to do your own homework and not just believe what salesman / installers are telling you as they are often restrained in their knowledge by the battery brand they are trying to sell.

In an effort to compare battery technologies a company called ITP renewables, in Canberra, set up a battery test site, https://batterytestcentre.com.au/ to conduct longitudinal performance testing of conventional and emerging battery technologies. This is an Arena funded testing facility set up to independently test and compare different battery technologies under Australian conditions for both performance and longevity for a 3 year period. This testing centre was first set up with Phase 1 in 2016 then phase 2 started in 2017. Originally it was for lithium-ion batteries only but now includes other technologies.

The SoNick battery is included in round 3 which started in 2019 and to date showing excellent results. 10 Previous 6 monthly reports are available from the test centre and can be download.at http://batterytestcentre.com.au/reports/

Continue reading “Not all batteries are equal” →

Protect Yourself from power outages from wind and storm damage

Posted on by Linda

Windy winter weather tends to bring trees down on power lines, cutting off your power supply as many people in Victoria have discovered recently. Many people in Gippsland and the Dandenongs are still without power a week after the storm that raged across Victoria on 9th June.

For many people the need to protect themselves from power outages is becoming a more and more common occurrence and it is not unusual for it to take days for the power to be reconnected, particularly if you are not on a main line and other lines take priority.

Continue reading “Protect Yourself from power outages from wind and storm damage” →

Yarram Circular Economy event – GridEdge report

Posted on by Linda

Recently GridEdge was part of the Yarram Circular Economy event on 23rd May 2021, hosted by Yarram Community Energy. GridEdge in conjunction with Regenerative Resources are working to set up a Renewable Energy Park at the Radial Timbers Sawmill in Yarram with the first stage involving a pyrolysis unit supported by a SoNick battery storage system.

Continue reading “Yarram Circular Economy event – GridEdge report” →